HomeMy WebLinkAboutAPPROVED ENGINEER LETTER - 22-00195 - 565 Terra Vista Dr - Solar PanelsAuthor Name Author Email Author Phone No.:
Larry Beesley Larry.Beesley@rexburg.org 208-372-2176
Description : 565 Terra Vista Dr - Solar Panels
Address : 565 Terra Vista Dr
Record Type : Solar Panels
Document Filename : 2022-03-31 Laney Engineering.pdf
Comment Author Contact Information:
Corrections in the following table need to be applied before a permit can be issued
Review Report
Approved
# 22-00195
Page Reference Annotation
Type
Author : Department Status Page Review Comments Applicant Response Comments
Pg 1 Stamp Larry Beesley : Building Open 1 Approved - Building Inspector
Pg 2 Stamp Larry Beesley : Building Open 2 Approved - Building Inspector
Solar Panels
Approval of plans does not constitute approval of variance from code
Powered by TCPDF (www.tcpdf.org)
9089 S 1300 W Suite 160, West Jordan, Utah 84088
Phone: 801-707-9004 Fax: 801-590-6611
Website: www.perigeecivil.com
Email: info@perigeecivil.com
March 31, 2022
Intermountain Wind and Solar
Attn: Ryan Shaw
1041 North 950 West
Centerville, UT 84014
RE: 565 Terra Vista Drive, Rexburg, ID
Structural Evaluation for Solar Panel Installation
Dear Ryan,
This letter is regarding the residence at the above referenced address. It’s our understanding that
Intermountain Wind and Solar would like to add solar panels to the structure in the area shown in the
attached sketch.
The solar panels proposed by Intermountain Wind and Solar are less than 4 pounds per square foot
(psf). The home was constructed in 2014 with pre-manufactured trusses, and typical design loads for
roofs in residential construction of that era are 10-15 psf, with a roof live load design of 20 psf and
roof snow load of 35 psf. Based on typical materials used in residential construction for asphalt roofs,
actual dead loads are generally less than that, around 7-8 psf. This would allow for 2-3 psf to be
added.
In compliance with the IRC 2018, which references Section 706.2 of the International Existing
Building Code (IEBC) 2018, alterations to a building which results in less than 5% of a gravity load
increase may be performed without structural evaluation of the existing structure, which would allow
an additional 2 psf. Because of these factors, it is our opinion that the roof is structurally adequate to
support the additional dead weight of the proposed solar panels. Supports from the array to the roof
should not be spaced greater than 4’ apart, and connections between adjacent railing rows should be
staggered.
Please contact me if you have questions or need further information.
Sincerely,
Letizia Wetzel, PE
3-23-2022
18
"
P
a
t
h
w
a
y
s