HomeMy WebLinkAboutINSPECTIONS - 02-00065 - Bowen Student Housing - RemodelINSPECrirlON TICKET
�C`213
$ldg. ❑ Plumb. ❑
Elect. ❑ Mech. Fire
9
0
i n
El DISAPPROVED
D NOT APPLICA
BeetAckrj()�vued
While , off, e COPY
YellO - Job
LJ N Lf ,1 N
U FINA L
U DID NQ7' Ih'SPECT
Ire Lt r
CITY OF REXBURG
BUILDING INSPECTION SEQUENCE
Type of Inspections., For on-site construction, from time to time the building official, upon
notification from the permit holder or his a�en#, shall mike or cause to be made any necessary
I
nspections and sha!l either approve that portion of the construction as completed or shad notify
the permit holder or his agent wherein the Sams fails t0 CUI'1'1ply with this cod�.
1. LAYOUT: Lot corners staked, staking in place for building , prier to excava#ian:
2• FOOTING: Commonly made after pokes or piers are sed or trenches or basement
areas are excavated. Forms and honzontal reinforcing tied in place,
vertical reinforcing cut and on job site or tied an place.
3. FOUNDATION INSPECTION
The foundation inspection shall included excavations for thickened slabs
intended for the support of bearing waCls,partitions, structural supports, or
equipment and special requirements for wood foundations. 'All forms and
reinforcing steel, etc., shall be in place.
4. PLUMBING, MECHANICAL AND ELECTRICAL:
Rough inspection: Commonly made prior to covering or concealment,
before fixtures are set, and prior to framing inspection.
5. TRUSS INSPECTION: l
inspections of trusses.�..-
6. FRAME INSPECTION:
Commonly made after the- road, all framing, firestopping, draftstopp"ng and
braying ars in place and after the plumbing, mechanical and electrical
rough inspections are approved.. (Electrical inspection performed through
State of Idaho Electrical Bureau}
7. LATH AND/OR WALLBOARD INSPECTION:
Commonly made after all lathing and/or wallboard interior is in place, but
before any plaster is applied, or before waIlE�aard points and fasteners are
taped and finished.
8. FINAL PLUMBING AND HEATING INSPECTION,
All systems in place, fixtures set, ready for occupancy
9. SIDEWALK INSPECTIONS:
After forms are sit, prior to placing concrete.
10. FINAL INSPECTION:
Commonly made after the building is completed and ready for occupancy.
OCCUPANCY71PERMIT.
Issued when, on final inspection, building is ready to occupy.
129 DINSPECTIONS:
In addition to the called inspections above, the building department may
make or require any other inspections to ascertain compliance with this
code and other laws enforced by the building department.
lNSPEGTIQN CARD
The Permit Raider 4r his went shall post the �nspec#ivn record on the job site in an accessible
and conspicuous place to allow the building official to mike the required entries. The record
shall be maintained by the permit holder until the final inspection has been made and approved.
i have read the above and will comply in my requests dor inspections by giving 24 HOUR
NOTICE prior dor inspections to be made.
Electrical: 624-3767 Building: 359-3U20 ex 326 or 313
Plumbing: 359-3D20 ex 325 0r 313 or 359-3Q34
Signature0
.,
Date:
-oz