HomeMy WebLinkAboutPRODUCT DATA - HANGING MATERIAL NO BLOCK - 18-00176 - 220 S 2nd W - Arbor Cove - Bldg (C) #2 - 32 Units - New Dormitory Housing514
OFFSET HANGER
CPVC - COPPER
STEEL•
SIZE SYSTEM PIPE:
MATERIAL
FINISH
PATENT No. 6,648,278.
FUNCTION
INSTALLATION
WOOD - #905
STEEL-
FEATURES
#905
ORDERING
906
- 3/4" thru 3"
- Carbon Steel.
- Mil. Galvanized..
-
-S
rovid vertical ateral restraint revents upward movement
of pipe that supplies a pendent sprinkler below ceiling.
-
including NFPA13, 13R, 13D and CPVC manufacturers instructions.
Install on horizontal or vertical mounting surface.
Snap over pipe then squeeze strap back allowing pipe to slide freely.
CPVC pipe - screw- no pre-drill.
Copper pipe -
Steel pipe - 1/4 x1 lag screw -
5/8 gypsum board - 1/4 x lag screw
min.
* 1 1/2 Offset
* 3/4 and 1 pipe size a e common center-line.
* Patented design for superior strength.
* Offset edge eliminates abrasion.
* screw included - 5/16" hex head.
- Part # and pipe size.
# backing nut sold separately.
AFCON
AFCON
LISTING/APPROVAL-
203 - EX 4231, EX 2551
Per these instructions
FASTENERS
#905
CONCRETE each =
upport horizontal piping: 3/4" -3" CPVC or Copper.
Support horizontal piping: 3/4" - 2" Steel.
Size 3/4" - 2" p es listed /l and p
a
Stabilize vertical piping.
When #905 threads are exposed in wood, install #906 backing nut.
- UL Listed per NFPA13
3/4" - 3"
3/4" - 2" screw- no pre-drill.
3/4" - 2" " 1/2" no pre-drill.
Thru " " 2" .
18 GA. - 3/4" - 3" CPVC pipe - 1/4" or #14 Tek Screw.
3/4" - 2" Copper pipe - 1/4" or #14 Tek Screw.
3/4" - 2" Steel pipe - 1/4" or #14 Tek Screw.
: Required minimum load fastener
" - loose fit allows pipe to slide.
" " m d with
•
5(wt)+250lbs.
2
1.5000
#905 #906
Listed Restraint
Listed Restraint
Specific products are exclusively designed to be compatible with other products including parts and fasteners, resulting in a listed sway brace, restrainer or hanger assembly.
the following warranty restriction will apply. - will warrant against the failure of its products when used in combination with other products, partsor systems
not manufactured or sold by . shall be liable under any circumstances whatsoever for any direct or indirect, incidental or consequential damages of any kind, including but not
limited to loss of business or profit, when non- products have been, or are used.
AFCON AFCON
AFCON
AFCON AFCON
AFCON
ONLY
Be advised DISCLAIMER NOT
NOT
3.00
10/08
P.O. Box 3365 South El Monte, CA 91733 626.444.0541 Fax 626.444.3887 www. Afcon.org
3/4 thru 2""
3/4 thru 2""
CADCADCAD